|
|
Carbon
Tech
4751 Pell #3 . Sacramento . California
. 95838
916.641.8088 main / 916.641.8087 Fax
|
| To
Clean and Prepare Carbon Tech Arrows |
- After
you have properly cut your Carbon Tech Arrows you
need to clean all of the carbon dust from the outside
and inside of the arrow shaft.
- Acetone
works the best, it is strong enough to clean effectively,
but not too strong to break down the arrow shaft resin.
Stay away from MEK it could possibly too strong and
break down the arrow shaft resin. (*Always use in
a well ventilated room, and stay away from flames
and smoking.)
- To
clean the outside of the arrow shaft take a rag and
pour a small amount of the acetone on it. Quickly
clean off the arrow shaft until you hear it squeak.
(That should be plenty clean)
|
|
|
|
- Fill
a paper or plastic cup with about 1" of the acetone.
- Quickly
dip the arrow shafts in the acetone one side at a
time.
- Make
sure that each side is dry before doing the other
side. Lightly tap the ends of the arrows on a paper
towel to remove excess acetone from the interior of
the arrow shaft.
|
|
